 |
| Be Different - Sound Better |
|
| Be Different - Sound Better |
|
INSTALLATION PROCESS We recommend installation by a qualified installer if possible. If one is not available follow the instructions below. 1. Calculate length of port needed:
 1. Determine proper speaker & port placement before cutting any holes. The Precision Port™ can be placed as close as 1” from the inside wall of the enclosure although it is recommended to keep it as far away from the inside wall as possible. 2. Once placement has been determined cut the proper size hole. 3. Trim center tube to 5” shorter than Lv from step one. 4. The Precision Port™ should be 1” longer than Lv when assembled. 5. If you want to use screws to attach the port to the enclosure use the guide marks on the back of the outside flare. The screw holes are numbered with a 6 or 8 for the number of screws you would like to use. 6. When the length has been achieved the Precision Port™ can be glued together using ordinary ABS adhesive or similar type glue. Once pieces are assembled with ABS adhesive, pieces can not be taken apart. Assemble the Precision Port™ in the following manner. 1. Attach connecting rings to flared ends. 2. Slide flared ends, with connecting rings attached, over tube section. DO NOT ATTACH INSIDE FLARE UNTIL PORT HAS BEEN INSTALLED IN ENCLOSURE. 7. Insert the Precision Port™ into enclosure and secure with adhesive and/or screws. It is recommended to use adhesive when screwing in port.
WARRANTY The Precision port™ is warranted, to the original purchaser, for a period of 90 days from the date of purchase. This warranty is limited to any manufacturing defects. If such a defect is found contact the place from which you purchased this product. |